Install brake booster

• Guide the brake booster (1)  into the bulkhead.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install the nuts (1)  and tighten.
• Replace nuts.

Parts:  Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

• Lock brake pedal (1)  in place in the arrow direction with the brake booster.

Ensure that the brake pedal is completely locked with the brake booster! 

Courtesy of BMW OF NORTH AMERICA, INC.

• Install the check valve (1)  in the brake booster in the arrow direction.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install air duct (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .
• Refer to INSTALLING THE TANDEM BRAKE MASTER CYLINDER .
• Refer to INSTALL EXPANSION TANK (VEHICLES WITH MANUAL TRANSMISSION) .
• Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to FLUSH AND VENT THE REAR AXLE BRAKE CIRCUIT .
• Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
• Refer to FLUSH AND BLEED THE FRONT AXLE BRAKE CIRCUIT (BRAKE HIGH) .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to IF INSTALLED: REMOVING STRUT BRACE IN THE REAR OF THE ENGINE COMPARTMENT .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .