Installing the rear wheel arch trim
NOTE:
TECHNICAL INFORMATION
To ensure optimal bonding, the bonding surfaces on the inner side of the wheel arch trim panels must not be painted!
You must apply the adhesive pad (two-sided adhesive tape) to the wheel arch trim panel before painting the wheel arch trim panel.
To ensure optimal bonding, the bonding surfaces on the inner side of the wheel arch trim panels must not be painted!
You must apply the adhesive pad (two-sided adhesive tape) to the wheel arch trim panel before painting the wheel arch trim panel.
- Remove adhesive residue at bonding surfaces (1) and (2) .
- Clean bonding surfaces (1) and (2) with cleaning agent R2.
| Consumable | ||
|---|---|---|
| Cleaning agent R2 | 500 ml | 83190417324 |
- Adhere to the air drying time of 2 min.
- Detach protective films from adhesive pads (double sided adhesive tape).
- Position the wheel arch trim (1)
and (2)
according to the specified dimensions and press down tightly.
Dimension a = approx. 2 mm.
Dimension b = approx. 2.5 mm.
Dimension = approximately 3.5 mm