Installing the guide for the rear bumper panel at the side
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Position the guide for the rear side bumper cover (3) .
- Lock (1) must engage audibly.
- Clip in the clips (2)
of the vehicle wiring harness.
- Tighten nuts (1) .
TIGHTENING TORQUE SPECIFICATION
| Rear bumper cover guide on the side of the body | ||
|---|---|---|
| Nut and washer assembly with paint scrape groove | Tightening torque | 5 Nm |
Follow-up work