Removing the cylinder head from the assembly jig

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2024 BMW M340i xDrive, 2024 BMW M340i, 2023 BMW M340i xDrive, 2023 BMW M340i, and 2022 BMW M340i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Heavy component .
Heavy components can lead to injury or damage .

Remove and install heavy components with the aid of another person/other persons.

Loosen screw (2) .
Feed out rod (1) in arrow direction and set aside.

Courtesy of BMW OF NORTH AMERICA, INC.
Release the screws (1) from the special tool 0 494 150 (11 9 440) .

Courtesy of BMW OF NORTH AMERICA, INC.
Stage the special tool (workshop crane) 2 220 718 .

Courtesy of BMW OF NORTH AMERICA, INC.
Prepare the special tool 0 490 567 (11 0 020) .

Courtesy of BMW OF NORTH AMERICA, INC.
Insert and position special tool 0 490 567 (11 0 020) on the cylinder head (1) .
Position the workshop crane 2 220 718 and connect it to special tool 0 490 567 (11 0 020) .

Courtesy of BMW OF NORTH AMERICA, INC.
Detach the cylinder head (1) with the workshop crane 2 220 718 and special tool 0 490 567 (11 0 020) from the device (2) , guide it out and remove.

Courtesy of BMW OF NORTH AMERICA, INC.