Installing the expansion tank (vehicles with automatic transmission)

• Replace rubber plugs (1)  .

  Parts:  Rubber plugs

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect expansion tank to the tandem brake master cylinder.
• Replace the retaining screw (1)  .

  Parts:  Retaining screw

• Fit and tighten the retaining screw (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connector (1)  .
• Hook the cable into holder (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to CONNECTING THE BLEEDER UNIT FOR BRAKE FLUID (AFTER REPAIR, TOP UP BRAKE FLUID) .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to IF INSTALLED: INSTALLING STRUT BRACE IN THE REAR OF THE ENGINE COMPARTMENT .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .