Installing the flywheel
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength .
The screw connection must be completed within 10 minutes as hardening begins after this period.
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength .
The screw connection must be completed within 10 minutes as hardening begins after this period.
- Make sure the centering hole (1) is on the centering pin (2) of the crankshaft.
- Position flywheel.
- Block the flywheel with special tools 0 494 129 (11 9 263)
(1) and 0 493 938 (11 9 260)
(2) and a
transmission bolt M10x55 (3).
- Replace screws (1) to (9).
Parts: Screws
- Tighten the screws (1) to (9).
TIGHTENING TORQUE SPECIFICATIONS
| Flywheel | ||
|---|---|---|
| Screw M12x1.5x28 Replace screws. |
Joining torque Angle of rotation |
45 Nm 45° |
- Release and remove the transmission bolt (3).
- Remove special tools 0 494 129 (11 9 263) (1) and 0 493 938 (11 9 260) (2).