Installing engine ventilation line of cylinder bank 1
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Insert the engine ventilation line (2) and turn it counter-clockwise.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Engine ventilation line | ||
|---|---|---|
| screw | Tightening torque | 9.3 Nm |
- Position engine ventilation line (2).
- Connect and lock retaining clip (1).
Follow-up work
- Refer to INSTALLING THE TANK VENTILATION LINE OF CYLINDER BANK 1 PARTIALLY .
- Refer to ATTACHING THE WIRING HARNESS SECTION FOR THE IGNITION SYSTEM OF CYLINDER BANK 1 .
- Installing cable duct at cylinder bank 1.
- Position the conduit (2).
- Tighten the screws (1).
TIGHTENING TORQUESCable duct M6x16 screw Tightening torque 10Nm - Refer to INSTALLING THE EXPANSION TANK FOR THE CHARGE AIR COOLER .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE COVER PANEL OF THE MASTER DME CONTROL UNIT .