Installing holder of the DME control unit for cylinders 5 to 8
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Carefully push the holder of the refrigerant line (3) aside.
- Insert holder with the DME control unit of cylinders 5 to 8 (2) and position.
- Engage the connector bracket (1).
- Ensure that the centering pin (2) is located in the lug (1) on the left spring support.
- Engage the cable bracket (1).
- Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
| DME control unit holder | ||
| screw | Tightening torque | 8 Nm |
- Tighten the screws (1).
TIGHTENING TORQUES SPECIFICATION
| DME control unit holder | ||
| screw | Tightening torque | 8 Nm |
- Connect connectors (1) and lock.
- Engage the cable bracket (2) in the adapter plate.
Follow-up work
- Refer to INSTALLING THE COVER PANEL OF THE SLAVE DME CONTROL UNIT .
- Refer to CONNECTING BATTERY GROUND LEAD .