1161 INTAKE PLENUM (230i, 230i xDrive)
1161 TIGHTENING TORQUE OVERVIEW
| Holder for intake plenum to cylinder head/crankcase | ||
| M6 | 10 Nm | |
| Holder for wiring harness to intake plenum | ||
| 5 Nm | ||
| Intake plenum to cylinder head | ||
| M6 | 10 Nm | |
| Intake plenum to cylinder head Observe TIGHTENING SEQUENCE . |
||
| M6 | Tightening torque | 10 Nm |
| Intake plenum to cylinder head | ||
| M6 | Tightening torque | 10 Nm |
| Intake plenum to rear/front holder | ||
| 8 Nm | ||
| Intake plenum to support | ||
| M6X25 | Tightening torque | 8 Nm |
| Manifold bracket for intake air at cylinder head | ||
| M6X16 | Tightening torque | 8 Nm |
| Manifold bracket on intake plenum | ||
| M6x25 | tightening torque | 8 Nm |
| Manifold bracket to crankcase | ||
| M6x16 | tightening torque | 8 Nm |
| Tank vent line to intake plenum | ||
| 5 Nm | ||