Replacing the rear side window
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Remove the adhesive bead with a scraper from the special tool 0 410 436
from the body.NOTE: TECHNICAL INFORMATION
Protect components against corrosion. Treat paint damage with corrosion protection. - Remove the rest of the guide pins (1) and dual lock tape (2). Clean bonding surface.CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Replace Dual Lock tape (2).
Parts: Dual Lock tape
- Apply Dual-Lock tape (2) in the area shown on the body.
Check
- Check tabs (1) on the trim strip on the rear side window (2) for damage.
Result
» Tabs (1) are damaged.
Measure
- Replace trim strip on the rear side window (2).
- Clip the trim strip (1) at the rear side window (2) into place.
a Position of adhesive bead 2 ±1 mm b Width of adhesive bead 8 ±2 mm C Height of adhesive bead 13+2 mm - Clean the bonding surfaces on the side window and the body.
- Apply adhesive bead to the cut back adhesive bead of the body.
- Apply adhesive bead as shown along the PVC encapsulation (3).
Apply bead joint in area (2).
NOTE: TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person. - Align the side window (1) with the special tool 0 492 609 (51 3010) on the side wall and guide in with the guide pins.
- Press the side window (1) onto the Dual-Lock tape.
- Fix the side window (1) with the plastic adhesive tape.CONSUMABLE SPECIFICATION
Yellow plastic adhesive tape 83199410979
Follow-up work
- Refer to INSTALLING THE SEAL ON THE FRONT SIDE WINDOW .
- Refer to INSTALLING B-PILLAR TRIM PANEL .
- Refer to INSTALLING C-PILLAR TRIM PANEL .
- Refer to INSTALLING REAR TRIM PANEL .
- Refer to INSTALLING THE SEAT BELT FINISHER STRIP .
- Refer to INSTALLING THE INNER DOOR SILL COVER STRIP .
- Refer to INSTALLING BACKREST SIDE SECTION .
- Refer to INSTALLING THE REAR SEAT .