Remove rear window
NOTE:
RISK OF DAMAGE
Fold the headlining.
Damage to the headlining. If necessary, the headlining must be replaced.
Fold the headlining.
Damage to the headlining. If necessary, the headlining must be replaced.
- Carry out tasks with a second person to assist.
- Support the headlining at the front and back.
Preliminary work
- Refer to REMOVING REAR SEAT BENCH .
- Refer to REMOVING LEFT AND RIGHT BACKREST SIDE SECTION .
- Refer to REMOVING THE INNER DOOR SILL COVER STRIP ON THE LEFT AND RIGHT .
- Refer to REMOVING THE SEAT BELT FINISHER STRIP AT THE LEFT AND RIGHT .
- Refer to REMOVING SIDE TRIM PANEL, REAR LEFT AND RIGHT .
- Refer to REMOVING RIGHT C-PILLAR TRIM PANEL LEFT AND RIGHT .
- Refer to TRIM OF THE 3RD BRAKE LIGHT .
- Refer to REMOVING THE BRAKE LIGHT .
- Unlock plug connections (1) and disconnect.
- Secure cable to rear window with adhesive tape.
- Loosen nut (1).
- Secure cable (2) to the rear window.
- Unlock plug connection (1) and disconnect.
- Secure cable (2) to rear window with adhesive tape.
- Tape off body in area of piercing point with fabric adhesive tape.
- Slide the cord along line (1) through the adhesive bead from the inside.
- Cut out the rear window using spider 2 357 248.
- Remove the rear window using special tool 2 184 377.
- Remove the adhesive bead on the body using special tool 0 410 436
and clean the adhesive area.