Removing and installing/replacing trim on center console at side left or right
When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).
Preliminary work needed:
- Refer to REMOVING TRIM FOR STORAGE COMPARTMENT .
- Refer to REMOVING CENTER CONSOLE COVER .
- Remove REAR CENTER CONSOLE COVER .
Unscrew the screws (1).
Remove screw (1).
Lever trim out of clamps (2).
Installation note:
Replace defective clips (2).
Unscrew the screws (1) .
Pull out decorative trim (2) upwards.