61 31 117 Removing and installing/replacing power window switch (driver's side)

Special tools required:

IMPORTANT: Carry out the following operation carefully so as to avoid damaging the door trim panel and switch.
If necessary, tape off working area.

Lever power window switch (1) out of armrest (2) in arrow direction using special tool 00 9 325 .

Disconnect associated plug connection and remove power window switch (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

The guide (1) and detents (2) on the trim (3) must not be damaged or missing.

Make sure that the power window switch is correctly seated in the armrest.

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release detents on both sides and feed power window switch (1) out of trim (2).

Courtesy of BMW OF NORTH AMERICA, INC.