51 47 151 Removing and installing/replacing left trunk wheel arch trim
Preliminary work needed:
- Refer to REMOVING LEFT SIDE TRIM PANEL .
- Refer to REMOVING COVER ON TAIL PANEL .
- Refer to REMOVING STORAGE SHELF (PARCEL SHELF) .
Unclip covers (1) and loosen the screws underneath.
Tightening torque 51 47 1AZ .
Remove the lashing eye.
Remove cross member trim panel (2) upwards.
Release expanding rivet (1).
If necessary, disconnect related plug connections.
Feed out trunk wheel arch panel (2) in arrow direction
Installation note:
Trunk wheel arch panel must fit correctly under trunk lid rubber seal (3) and shoulder (4).