52 13 002 Removing and installing front seat, passenger's side
WARNING:
High-voltage system - mortal hazard!
The following points must be strictly observed prior to starting work:
DE-ENERGIZE THE HIGH-VOLTAGE SYSTEM
Observe SAFETY INSTRUCTIONS ON HANDLING HYBRID OR ELECTRIC VEHICLES
The following points must be strictly observed prior to starting work:
DE-ENERGIZE THE HIGH-VOLTAGE SYSTEM
Observe SAFETY INSTRUCTIONS ON HANDLING HYBRID OR ELECTRIC VEHICLES
Preliminary work needed:
- Refer to DISCONNECTING CABLE FROM BATTERY EARTH LEAD .
IMPORTANT:
An airbag module and a pyrotechnical seat belt tensioner are installed in the front seat.
Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.
Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.
Shift seat to upper back position.
Unscrew the screws (1).
NOTE:
Replace screws.
Tightening torque 52 10 1AZ .
Tightening torque 52 10 1AZ .
Adjust the seat to the front top.
Unscrew the screws (1).
NOTE:
Replace screws.
Tightening torque 52 10 1AZ .
Tightening torque 52 10 1AZ .
Unlock PLUG CONNECTION (1) and disconnect.
IMPORTANT:
Cover door sill with protective covers (risk of damage).
Lift out front seat.
Installation note:
- Carpet must not get between seat rails and floor panel in area of attachment points (creakings)
- Insert all screws loose to avoid twisting
- Replace all screws and tighten to the specified torque
Tightening torque 52 10 1AZ .
WARNING:
When carrying out further work on the front seat, it is absolutely imperative to observe the SAFETY REGULATIONS
on handling airbag modules and pyrotechnical seat belt tensioners
Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.
Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.