Replace storage net on instrument panel trim, bottom center

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Preliminary work needed: 

• Refer to DISMANTLING INSTRUMENT PANEL TRIM AT BOTTOM CENTER .

Removal: 

Unclip frame (1) in arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws and remove the storage net (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Secure storage net (1) with the screws.

Tightening torque 51 45 9AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Clean adhesive area (1) on storage net (2) and corresponding counterpart on the frame.

Apply adhesive from ADHESIVE SET K6  on adhesive area (1) on storage net (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Clip on frame (1) on the storage net (2).

No gap shall be visible in area (A) between the frame (1) and the trim panel (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install INSTRUMENT PANEL TRIM, BOTTOM CENTER .