51 43 070 Removing and installing/replacing side trim panel, footwell, on A-pillar, left

Preliminary work needed: 

• Refer to REMOVING FRONT DOOR SILL COVER STRIP (INSIDE) .
• Refer to REMOVING TRIM PANEL FOR PEDAL MECHANISM .

Detach edge protection (1) in area of side trim panel (2).

Loosen screws (3).

Release side trim panel (2) from clip (4) in arrow direction and remove.

Unlock and disconnect plug connections, according to the equipment.

Installation note: 

Make sure edge protection (1) is correctly seated.

If necessary, lever out clip (4) remaining in hole and attach to side trim panel (2).

Courtesy of BMW OF NORTH AMERICA, INC.

When replacing, remount the following parts according to the equipment.: 

• ENGINE COMPARTMENT UNLOCKING SWITCH .
• FUEL FILLER FLAP UNLOCKING SWITCH .
• TAILGATE RELEASING SWITCH .