51 14 010 Removing and installing/replacing rear BMW nameplate

Special tools required:

00 9 322

IMPORTANT: The NOTES on component bonding with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.

When removing BMW nameplate (1), do not damage mount (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully heat BMW nameplate (1) with hot air blower and lever out with special tool 00 9 322 .

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Detach liner* off adhesive tape (1).

Position plate over guides (2 and 3) and press down firmly.

* Liner is the protective film on a new plaque.

Courtesy of BMW OF NORTH AMERICA, INC.