Remove, install/replace C-pillar cover
Special tools required:
- 00 9 325
IMPORTANT:
The NOTES on component bonding with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.
Removal:
Mark position of the trim (1) with adhesive tape.
Heat cover (1) using a hot air blower and remove from side window (2) using special tool 00 9 325 .
Installation:
Clean the adhesive area.
Detach liner* of trim (1).
Align trim (1) to adhesive tape and bond on.
Bonding with new side window glass:
Bond trim (1) according to dimensions (A and B) to the door window glass (2) and to the side panel (3).
A = 5 ± 1 mm (parallelism deviation maximum 2 mm)
B = 3.5 ± 2 mm
Apply thumb pressure force over entire bonding surface of cover (1).
*Liner is the protective film on adhesive tape.