63 25 003 Removing and installing/replacing auxiliary brake light
Preliminary work needed:
- Refer to REMOVING REAR SPOILER .
Release expanding rivet (1).
Unscrew the screws (2).
Tightening torque 63 25 1AZ .
Remove trim (3) from rear spoiler.
Unscrew the screws (1).
Tightening torque 63 25 1AZ .
Remove auxiliary brake light (2) from rear spoiler (3).
Replacement:
REMOUNTING SPRAY NOZZLE FOR REAR WINDOW WASHER SYSTEM .
As from version 03/2014, adapter cable (1) is installed on auxiliary brake light with connector (A), wiring harness on vehicle installed correspondingly with connector (B).
Up to version 03/2014, adapter cable (1) is installed on auxiliary brake light with connector (B), wiring harness on vehicle installed correspondingly with connector (A).
If the auxiliary brake light is replaced up to version 03/2014, the previous adapter cable must still be used.
In the event of malfunctions due to the previous adapter cable (1), the new part as from 03/2014 must be used, but in this case the (A) pin contacts and pin housing (6 925 626) must be replaced by (B) socket contacts and socket housing (8 373 575).
Also refer to SPECIAL TOOLS FOR WIRING HARNESS REPAIR .