Installing the front brake disc chamber (High brake)

• If an arrow 1 is stamped on the brake disk, it must point in the driving direction!

  In this case, the left and right brake disks are different!

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.

• Clean contact surface of wheel hub thoroughly and remove any traces of rust if necessary.

  Unevenness of the contact surface could cause distortion of the brake disk!

• Mount brake disk (2).
• Position and tighten the screw (1).
• Replace the screw (1).

  Parts  : Screw

  TIGHTENING TORQUE SPECIFICATION
  
  

  Brake disc to front wheel hub
  M8 Replace screw.	Tightening torque	16 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Mount the brake caliper in the arrow direction.
• Insert screws (1) and tighten.
• Replace screws (1).

  Parts  : Screws

  TIGHTENING TORQUE SPECIFICATION
  
  

  Brake caliper/brake anchor plate at front swivel bearing
  M12 Replace screw.	Tightening torque	130 Nm

Follow-up work 

• Refer to GREASE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE (BRAKE HIGH) .
• Refer to INSTALLING FRONT PADS (HIGH BRAKE) .
• Refer to ADHESION OF BRAKE PADS TO BRAKE PISTONS .
• Refer to INSTALLING THE FRONT BRAKE PAD WEAR SENSOR (HIGH BRAKE) .
• Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
• Refer to COMMISSIONING OR BEDDING IN (BRAKE) OF NEW BRAKE PADS AND DISCS (HIGH BRAKE) .