Installing speaker and bracket

• Position the speaker holder (2)  .
• Connect all plug connections and clip in the cable bracket.
• Fit the speaker holder (2)  .
• Tighten down screws (1)  .
  TIGHTENING TORQUE SPECIFICATION
  
  

  Loudspeaker to support/support to dashboard/support to body
  Screw	Tightening torque	1.8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to ATTACHING THE INNER PANEL FOR THE LUGGAGE COMPARTMENT PARTITION WALL .
• Refer to INSTALLING THE REAR CENTER CONSOLE TRIM .
• Refer to INSTALLING LEFT AND RIGHT REAR SIDE TRIM PANEL .
• Refer to INSTALLING THE TRIM PANEL FOR THE LEFT AND RIGHT BODY PILLAR .
• Refer to INSTALLING THE LEFT AND RIGHT SEATBELT FINISHER STRIP .
• Refer to INSTALLING THE TRIM PANEL FOR THE TOP ROLLOVER PROTECTION .
• Refer to INSTALLING THE STORAGE NET .