Installing fog light support
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Correctly position the fog light bracket (3) and engage at detents (arrows).
- Tighten down screw (2)
.TIGHTENING TORQUE SPECIFICATIONS
Front fog lamp holder to bumper panel screw Tightening torque 3 Nm - Mount blind rivet (1) using the special tool 0 496 521 (00 2 230) .
- Position holder (2) .
- Tighten down screw (1)
.TIGHTENING TORQUE SPECIFICATIONS
Front fog lamp holder to bumper panel screw Tightening torque 3 Nm