Install the module bracket on the rear door

WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Check

Check the peripheral seal (1) on the module bracket (3) for damage.
Check the locks (2) for damage.

Courtesy of BMW OF NORTH AMERICA, INC.

Result

» The seal (1) on the module bracket (3) is damaged.

Measure

Replace the module bracket (3).

Result

» The locks (2) are damaged.

Measure

Replace the locks (2).

Correctly position the module bracket (3) and close the locking mechanisms (2).
Clip in the vehicle wiring harness (1) on the module bracket (3) and connect and lock the connectors.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Module bracket to door
screw	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Release the adhesive tape and manually lower the door window glass (1) until it engages in the holder (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING REAR DOOR TRIM PANEL .
Refer to INSTALLING THE OUTER WINDOW CHANNEL STRIP ON THE REAR DOOR .

Check

Check the peripheral seal (1) on the module bracket (3) for damage.
Check locks (2) for damage.

Courtesy of BMW OF NORTH AMERICA, INC.

Result

» The seal (1) on the module bracket (3) is damaged.

Measure

Replace the module bracket (3).

Result

» The locks (2) are damaged.

Measure

Replace the locks (2).

Correctly position the module bracket (3) and close the locking mechanisms (2).
Clip in the vehicle wiring harness (1) on the module bracket (3) and connect and lock the connectors.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Module bracket to door
screw	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING REAR DOOR TRIM PANEL .