install the vibration absorber on the trunk lid
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Position the vibration absorber (2) on the tailgate.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Vibration absorber to tailgate | ||
|---|---|---|
| M6 screw | Tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING REAR WINDOW WIPER MOTOR .
- Refer to INSTALLING THE TAILGATE TRIM PANEL .
- Refer to INSTALLING TRUNK COMPARTMENT LIGHT ON TRUNK LID .
- Refer to INSTALLING THE POWER TAILGATE SWITCH .
- Refer to INSTALLING THE TRIM FOR THE LEFT AND RIGHT SIDE REAR WINDOW FRAME .
- Refer to INSTALL THE TRIM FOR THE TOP REAR WINDOW FRAME .
- Refer to INSTALLING WIPER ARM OF THE REAR WIPER .