Installing the center safety partition wall
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Prerequisite
Rear seat backrests are folded.
CAUTION:
Heavy component
.
Heavy components can lead to injury or damage .
Heavy components can lead to injury or damage .
- Remove and install heavy components with the aid of another person/other persons.
NOTE:
TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person.
Conduct the following operation with the assistance of a second person.
- Install the safety partition wall (5) and position it correctly.
- Apply a drop of screw locking agent to the threads of each screw and nut before screwing.
ADHESIVE SPECIFICATIONS
| Screw lock Loctite Stick 243, medium strength | 10 ml, Bottle | 83192210339 |
- Tighten the screws (4).
TIGHTENING TORQUE SPECIFICATIONS
| Safety partition wall at the center to the holder | ||
| Hexagon screw M8x25 | tightening torque | 35 Nm |
- Tighten the screws (3).
TIGHTENING TORQUE SPECIFICATIONS
| Safety partition wall at the center to the safety partition below | ||
| Hexagon screw M8x30 | tightening torque | 35 Nm |
| Nut M8 | tightening torque | 10 Nm |
- Tighten nuts (2).
TIGHTENING TORQUE SPECIFICATIONS
| Safety partition wall at the center to the safety partition below | ||
| Hexagon screw M8x30 | tightening torque | 35 Nm |
| Nut M8 | tightening torque | 10 Nm |
- Fit the holder and tighten the nut (1).
TIGHTENING TORQUE SPECIFICATIONS
| Holder for tailgate release to the safety partition wall at the center | ||
| Nut M6 | tightening torque | 5.0 Nm |
- Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Safety partition wall (rear shelf) to the safety partition wall at the center | ||
| Flat-head screw M8x22 | tightening torque | 20 Nm |