Installing the vibration damper
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the contact surface of the central bolt (7).
- Align and position vibration damper for the Woodruff key of the sprocket wheel.
- Position shim (4).
- Position fitting sleeve (2).
The notches (6) of the fitting sleeve (2) must point to the counter support (5) .
- Position counter support (5).
- Tighten the screws (1) and (3) hand-tight.
- Replace central bolt (2).
Parts: Central bolt
- Treat the contact surface (1) of the central bolt (2) with lubricating grease.
CONSUMABLE SPECIFICATIONS
| Lubricating grease SYNTHESO GLEP 1 | 100 g, Tube | 83239407778 |
- Tighten central bolt (7).
TIGHTENING TORQUE SPECIFICATIONS
| Central bolt | ||
| Screw M18x1.5x122 Replace screw. Replace screws grease screw head see Consumables 4.8 |
Joining torque 1. Angle of rotation 2. Angle of rotation 3. Angle of rotation |
100 Nm 60° 60° 60° |
- Release the counter support (5) and shim (4) with the screws (1).
- Release the fitting sleeve (2) and counter support (5) with the screw (3).
- Remove the counter support (5) from the vibration damper.
- Remove the fitting sleeve (2).
Follow-up work
- Refer to INSTALLING THE BELT PULLEY ON THE TORSIONAL VIBRATION DAMPER .
- Refer to INSTALLING THE BELT TENSIONER .
- Refer to INSTALLING DRIVE BELT .
- Refer to CHECKING THE COOLANT LEVEL IN THE LOW-TEMPERATURE COOLANT CIRCUIT AND TOPPING UP, IF NEEDED .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING THE RIGHT AND LEFT UNFILTERED-AIR DUCT .
- Refer to INSTALLING BOTH INTAKE FILTER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING TENSION STRUT ON LEFT AND RIGHT SHOCK TOWER .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT , and INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE TOP RIGHT .