Installing the left-hand charge air cooler

• Check the seal (1) for damage and replace if necessary.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert and install the left-hand charge air cooler (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the charge air cooler (1) on the left as shown in the illustration.
• Connect and lock the coolant line (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in and install coolant line (2).
• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Charge air cooler to holder
  M6x35	Tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Alternator to cylinder head
  M8x85	Tightening torque	22 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Lock clamp (1).

  The clamp (1) must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1) and lock.

  The connector (1) must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Check sealing ring (1) for damage, replace if necessary.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach the tank vent line (3) to the clamps (arrowed).
• Insert and install charge air line (2).
• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Connecting hose to charge air cooler
  Hexagon screw M6	Tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the coolant line (3).

  The coolant line (3) must audibly engage.

• Feed in and install the tank vent valve with the bracket (2).
• Ensure that the locking mechanism (1) engages audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING LEFT CLEAN AIR PIPE .
• Refer to CONNECTING THE LEFT CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER .
• Refer to CONNECTING THE COOLANT HOSE TO THE AUXILIARY COOLANT PUMP .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
• Refer to INSTALLING INTAKE FILTER HOUSING .
• Refer to INSTALLING THE RIGHT STRUT BRACE .
• Refer to INSTALLING THE STRUT BRACE .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING TENSION STRUT ON LEFT AND RIGHT SHOCK TOWER .
• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
• Refer to FILLING AND VENTING THE LOW-TEMPERATURE COOLANT CIRCUIT .