Install heat shield, top
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Install top heat shield (2).
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Heat protection plate | ||
| M6x16 | tightening torque | 10 Nm |
Install the engine ventilation line of cylinders 5 to 8
- Position and guide in the engine ventilation line (3) towards the front.
- Position the intake pipe (2).
- Connect and lock intake pipe (2) and engine ventilation line (3).
- The retaining clips (1) must audibly engage.
- Position the engine ventilation line.
- Tighten the screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Engine ventilation line | ||
| screw | Tightening torque | 9.3 Nm |
Follow-up work
- Refer to INSTALLING THE LEFT INTAKE SILENCER BRACKET .
- Refer to INSTALLING THE LEFT LAMBDA OXYGEN SENSOR .
- Refer to INSTALLING THE RIGHT LAMBDA OXYGEN SENSOR .
- Refer to INSTALLING THE RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .