Installing the tension strut at the right rear and if necessary, on the left side
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Installing the right rear tension strut
Installing the rear tension strut
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Install the tension strut (3).
- Tighten the screws (1) and the nut (2).
TIGHTENING TORQUE SPECIFICATIONS
| Torsion strut on body and holder | ||
| M12x25 Replace screws. |
Joining torque Angle of rotation |
100 Nm 90° |
| Nut M10 | Tightening torque | 38 Nm |
Installing the undershield (tank cover) at right
NOTE:
Description is for left component only. Procedure on the right side is identical.
Installing undershield (tank cover)
- Insert the undershield (1).
- Tighten all bolts and nuts (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Undershield, side | ||
| Hexagon screw | Tightening torque | 2.6 Nm |
| Plastic nut | Tightening torque | 2.6 Nm |
For dual-flow exhaust system:
Installing the rear left tension strut
Installing the rear tension strut
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Install the tension strut (3).
- Tighten the screws (1) and the nut (2).
TIGHTENING TORQUE SPECIFICATIONS
| Torsion strut on body and holder | ||
| M12x25 Replace screws. |
Joining torque Angle of rotation |
100 Nm 90° |
| Nut M10 | Tightening torque | 38 Nm |
Installing undershield (tank cover)
- Insert the undershield (1).
- Tighten all bolts and nuts (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Undershield, side | ||
| Hexagon screw | Tightening torque | 2.6 Nm |
| Plastic nut | Tightening torque | 2.6 Nm |