Install all ignition coils

WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The description is for one component only. The procedure is identical for all further components.

Install ignition coil

Install ignition coil (3).

Tighten down screw (2).

TIGHTENING TORQUE SPECIFICATIONS

Ignition coil
screw	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connectors (1) and lock.
The connector (1) must engage audibly.
Mount the connector (1) of the Lambda oxygen sensor and the oxygen sensor monitor on the cable duct (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to MOUNTING THE SERVICE OPENING IN THE SOUND INSULATION ON TOP OF THE ENGINE .
Refer to INSTALLING ACOUSTIC COVER .