Installing the door sill trim panel
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Prerequisite
Front door is open.
NOTE:
RISK OF DAMAGE
Mechanical effects .
Paint damage .
Mechanical effects .
Paint damage .
- Mask those working areas at risk with yellow plastic adhesive tape.
- Remove and install heavy or bulky components with the aid of another person/other persons.
- If required, connect relevant connector.
- Guide the door sill trim panel (1) in carefully and position it.
- Engage door sill trim panel (1) from the front beginning with the detents along the dotted line.
- Engage door sill trim panel (1) at the clip (2).
- Tighten all bolts and nuts (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Undershield, side | ||
|---|---|---|
| Hexagon screw | Tightening torque | 2.6 Nm |
| Plastic nut | Tightening torque | 2.6 Nm |
- Check clips (2) and sealing rings for damage.
Replace damaged clips (2).
- Clip the rear wheel arch trim (1) onto the clips (2).
Follow-up work
- Refer to INSTALLING THE REAR DOOR .
- Refer to PARTIALLY INSTALLING THE FRONT WHEEL ARCH TRIM (DOOR SILL) .