Install reinforcement strut
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Feed in reinforcement strut (2).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Front reinforcement strut | ||
|---|---|---|
| screw | Tightening torque | 24 Nm |
Follow-up work
- Refer to INSERT TOP AUTOMATIC AIR FLAP CONTROL .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT , and INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE TOP RIGHT .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to PARTIALLY INSTALLING THE LEFT FRONT AND RIGHT WHEEL ARCH TRIM .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .