Installing the safety partition wall (rear shelf)
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Prerequisite
Rear seat backrests are folded.
NOTE:
TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person.
Conduct the following operation with the assistance of a second person.
- Guide in the safety partition wall (rear shelf) from the luggage compartment to the top and position it correctly.
- Before screwing, apply a drop of screw locking agent on the thread of each screw (1).
ADHESIVE SPECIFICATIONS
| Screw lock Loctite Stick 243, medium strength | 10 ml, Bottle | 83192210339 |
- Screw in screws (1) from the luggage compartment with a few turns.
- Before screwing, apply a drop of screw locking agent on the thread of each screw.
ADHESIVE SPECIFICATIONS
| Screw lock Loctite Stick 243, medium strength | 10 ml, Bottle | 83192210339 |
- Tighten the screws (arrows) from the vehicle interior.
TIGHTENING TORQUE SPECIFICATIONS
| Safety partition wall (rear shelf) to the safety partition wall at the center | ||
|---|---|---|
| Flat-head screw M8x22 | tightening torque | 20 Nm |
- Tighten screws (1) from the luggage compartment.
TIGHTENING TORQUE SPECIFICATIONS
| Safety partition wall (rear shelf) to the safety partition wall above | ||
|---|---|---|
| Flat-head screw M8x22 | tightening torque | 35 Nm |