Removing the top safety partition wall
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Prerequisite
- Luggage compartment wheel arch trim panels are removed.
CAUTION:
Heavy component
.
Heavy components can lead to injury or damage .
Heavy components can lead to injury or damage .
- Remove and install heavy components with the aid of another person/other persons.
Preliminary work
- Refer to REMOVING ALL GRAB HANDLES .
- Refer to REMOVING LEFT AND RIGHT SUN VISORS .
- Refer to REMOVING THE COUNTER SUPPORT FOR THE SUN VISOR ON THE LEFT AND RIGHT .
- Refer to REMOVING THE ROOF FUNCTION CENTER (FZD) .
- Refer to REMOVING A-PILLAR TRIM PANEL, LEFT AND RIGHT .
- Refer to REMOVING THE TOP LEFT AND RIGHT B-PILLAR TRIM PANELS PARTIALLY .
- Refer to REMOVING LEFT AND RIGHT BACKREST SIDE SECTION .
- Refer to REMOVING THE C-PILLAR TRIM PANEL ON THE BOTTOM LEFT AND RIGHT .
- Refer to REMOVING RIGHT C-PILLAR TRIM PANEL LEFT AND RIGHT .
- Refer to REMOVING THE LEFT AND RIGHT D-PILLAR TRIM PANEL .
- Refer to REMOVING THE SAFETY PARTITION WALL (REAR SHELF) .
- Refer to REMOVING THE LEFT AND RIGHT LUGGAGE COMPARTMENT TRIM PANELS .
- Refer to REMOVING THE CENTER SAFETY PARTITION WALL .
- Refer to LOWERING HEADLINING .
- Refer to PARTIALLY RELEASING THE PROTECTIVE PLATE ON THE ROOF .
Prerequisite
Rear seat backrests are folded.
CAUTION:
Heavy component
.
Heavy components can lead to injury or damage .
Heavy components can lead to injury or damage .
- Remove and install heavy components with the aid of another person/other persons.
NOTE:
Perform the steps on the right and left side.
- Loosen screws (1).
- Remove the protective plate (2).
NOTE:
TECHNICAL INFORMATION
Carry out the following steps with the help of 3 support persons:
2 persons are present in the vehicle interior, 2 persons are outside the vehicle.
Carry out the following steps with the help of 3 support persons:
2 persons are present in the vehicle interior, 2 persons are outside the vehicle.
- Loosen screws (1).
- Carefully thread out the safety partition wall (2) at the protective plate on the roof.
In doing so, make sure that the safety partition wall (2) at the bottom and top is supported with hands.
- Pass the safety partition wall (2) from the vehicle interior through the tailgate cutout to the persons standing outside the vehicle.