Take engine out of installation orientation

WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Lower engine by turning the spindle 2 361 506 (00 6 103) until the engine rests completely on the engine mounts.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.

NOTE: TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person.

Courtesy of BMW OF NORTH AMERICA, INC.

Remove the engine bridge (1) with the help from another person.

NOTE: TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person.

Carefully guide out and remove special tools 0 496 437 (00 6 052) and 0 496 438 (00 6 053) .
Remove the engine bridge.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen the screws (1) from the special tool 2 459 012 .
Guide the special tool 2 459 012 out and remove.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten screw (1) of the engine mount, right, using standard tool, from above.

TIGHTENING TORQUE SPECIFICATIONS

Engine mount to engine support bracket
M12	tightening torque	100 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Prepare special tool 0 493 751 (11 9 150) as shown.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten the screw of the left engine mount from the bottom with the special tool 0 493 751 (11 9 150) .

TIGHTENING TORQUE SPECIFICATIONS

Engine mount to engine support bracket
M12	tightening torque	100 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Install the reinforcement strut (2).
Tighten down screw (1).

TIGHTENING TORQUE SPECIFICATIONS

Engine mount reinforcement strut on front subframe
M12	tightening torque	110 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screw (1).

TIGHTENING TORQUE SPECIFICATIONS

Engine mount reinforcement strut on body
M12	tightening torque	110 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE CLEAN AIR PIPE AND THE RESONATOR .
Refer to INSTALLING THE INTAKE FILTER HOUSING (TENSION STRUT REMOVED ON SHOCK TOWER) .
Refer to INSTALLING THE TENSION STRUT ON THE RIGHT SHOCK TOWER .
Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT , and INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE TOP RIGHT .
Refer to INSTALLING THE FRONT HOOD SEAL .
Refer to INSTALLING ACOUSTIC COVER .
Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER .
Refer to PARTIALLY INSTALLING THE FRONT WHEEL ARCH TRIM (DOOR SILL) .
Refer to ATTACHING THE FRONT LEFT WHEEL .
Refer to INSTALLING THE STIFFENING PLATE .
Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
Refer to TAKING HOOD OUT OF THE SERVICE POSITION .