Releasing the wiring harness from the active stabilizer
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Unlock plug connection (1) and disconnect.
- Remove screws (arrows).
- Unlock plug connection (2) and disconnect.
- Release the cable with the holders (3) from the side member.