Install the lower oil pan section

NOTE: TECHNICAL INFORMATION
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength .
The screw connection must be completed within 10 minutes as hardening begins after this period.

Courtesy of BMW OF NORTH AMERICA, INC.

Clean the sealing surface in the area of (1) with the special tool 0 495 102 (11 4 470) .
Remove the seal (1).
Clean sealing surfaces with special tool 0 495 102 (11 4 470) .
Replace the seal (1).
Parts: Seal
Position the seal (1) on the lower oil pan section (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Position the lower oil pan section.
Replace screws.
Parts: Screws
Tighten the screws in this area (1).

TIGHTENING TORQUES SPECIFICATION

Lower oil pan section to upper oil pan section
M8 Replace screws.	tightening torque	27 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connectors (2) and lock.
Attach the cable clip (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to TIGHTENING THE OIL DRAIN PLUG .
Refer to REMOVING THE OIL FILLER CAP .
Refer to FILLING ENGINE OIL .
Refer to INSTALLING THE OIL FILLER CAP .
Refer to CHECKING ENGINE OIL LEVEL .