Installing the flywheel

NOTE: TECHNICAL INFORMATION
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.

Courtesy of BMW OF NORTH AMERICA, INC.

Make sure the centering hole (1 ) is on the centering pin (2 ) of the crankshaft.
Position flywheel.
Block the flywheel with special tools 0 494 129 (11 9 263) (1) and 0 493 938 (11 9 260) (2) and a transmission bolt M10x55 (3 ).

Courtesy of BMW OF NORTH AMERICA, INC.
Replace screws (1 ) to (9 ).
Parts: Screws

Tighten the screws (1 ) to (9 ).

TIGHTENING TORQUE SPECIFICATIONS

Flywheel
Screw M12x1.5x28 Replace screws.	Joining torque	45 Nm
	Angle of rotation	45°

Fig 1: Flywheel Screws Tightening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.

Release and remove the transmission bolt (3 ).
Remove special tools 0 494 129 (11 9 263) (1 ) and 0 493 938 (11 9 260) (2 ).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING AUTOMATIC TRANSMISSION
Refer to FASTENING THE PROP SHAFT (PARTIALLY REMOVED) .
Refer to INSTALLING THE RETAINING PLATES .
Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
Refer to INSTALLING THE HEAT SHIELDS .
Refer to INSTALLING EXHAUST SYSTEM .
Refer to INSTALLING THE LEFT AND RIGHT REAR DIFFUSER .
Refer to INSTALLING THE RIGHT REAR TENSION STRUT
Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
Refer to CHECKING/TOPPING UP THE OIL LEVEL IN THE AUTOMATIC TRANSMISSION .
Refer to INSTALLING THE STIFFENING PLATE
Refer to INSTALLING FRONT UNDERBODY PROTECTION .
Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
Refer to ENCODING/PROGRAMMING CONTROL UNIT(S)