When replacing the glove box lid

Preliminary work 

• Refer to REMOVING THE SIDE PANEL ON THE RIGHT DASHBOARD .
• Refer to REMOVING RIGHT FOOTWELL TRIM .
• Refer to REMOVING GLOVE BOX LIGHT .
• Refer to REMOVING GLOVE COMPARTMENT .
• Refer to REMOVING GLOVE BOX LID .

• The closure of the glove box lid and the lock cylinder cannot be removed without destroying them and must always be replaced  .

  Assembling the lock cylinder 

• Sort the enclosed guard controls (1) as per the graphic.

  X  = number embossed on the guard control (1)

  Y  = installation position in the lock cylinder

  Courtesy of VOLVO CARS CORPORATION

  NOTE: The description is provided only at one component. The procedure is the same for all other components.
• Insert the spring (1) into the lock cylinder (2).

  Courtesy of VOLVO CARS CORPORATION

• Insert and engage the guard control (1) with the lowest embossed number X  into position Y  of the lock cylinder (2).

  The guard control engages audibly.

  Courtesy of VOLVO CARS CORPORATION

  Check 

  • Insert the ignition key (1) into the lock cylinder (3).
  • Check whether the guard control (2) is flush with the housing.

  Courtesy of VOLVO CARS CORPORATION

  Result 

  » The guard control (2) is not flush with the housing (B).

  Measure

  • Press out the guard control (2) from the lock cylinder (3) using a suitable tool.

  Measure

  • Repeat the operations using the guard control with the next higher number X  , until the guard control is flush with the housing (A).
• Insert the lock cylinder (1) with the ignition key in the glove box lock (2) and press to engage.

  Courtesy of VOLVO CARS CORPORATION

• Carefully insert the glove box lock (1) in the glove box lid (2) and lock.

  Courtesy of VOLVO CARS CORPORATION

Follow-up work 

• Refer to INSTALLING GLOVEBOX COVER .
• Refer to INSTALLING GLOVE COMPARTMENT .
• Refer to INSTALLING THE GLOVE BOX LIGHT .
• Refer to INSTALLING RIGHT FOOTWELL TRIM .
• Refer to INSTALLING THE SIDE PANEL ON DASHBOARD ON THE RIGHT .