Install front brake hose

• Attach brake hose to the holder (1).

  Observe installation sequence:

  • Secure brake hose in the holders.
  • Move wheels into straight-ahead position.
  • Screw brake hose onto the connection between pipe and brake hose.
  • Screw brake hose on brake caliper.
• Position and tighten the union screw (2). If necessary, use the square end (3) for counter support.

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUES SPECIFICATION
  
  

  Brake pipe screw connection/Union screws
  	tightening torque	17 Nm

• Position and tighten the brake hose (1) on the brake caliper and use the knurling (2) for counter support as needed.
  TIGHTENING TORQUES SPECIFICATION
  
  

  Brake hose to brake caliper, front
  	tightening torque	17 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach brake hose to the holder (3).

Follow-up work 

• Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
• Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to FLUSHING AND BLEEDING FRONT BRAKES (AFTER PART EXCHANGE) .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .