Insert top automatic air flap control
- Connect top air flap control (3) with the appropriate connector.
- Feed out air flap control, top (3) and clip the holder (1), left and right into the ball head (2).
- Tighten the screws (1).TIGHTENING TORQUE SPECIFICATIONS
Air flap control/brake ventilation duct Screw tightening torque 4 Nm
Follow-up work
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to PARTIALLY INSTALLING THE LEFT FRONT AND RIGHT WHEEL ARCH TRIM .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .