Install the tail light on the trunk lid

Check 

• Check the seal (1) and the snap-in lugs (2) of the tail light (3) for damage.

  Courtesy of BMW OF NORTH AMERICA, INC.

  Result 

  » The seal (1) or the snap-in lugs (2) are damaged.

  Measure

• Replace seal (1) or tail light (3).

  Parts:  Seal, tail light

• Position the tail light (1) at the trunk lid (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Lock the detent (1).

  The snap-in lugs must engage audibly.

• Tighten nuts (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Tail light at trunk lid
  M5 nut	tightening torque	2.3 Nm

• Connect connectors (1) and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE TRUNK LID HANDLE .
• Refer to INSTALLING THE REAR VIEW CAMERA (RFK) .
• Refer to INSTALLING THE TAILGATE TRIM PANEL .
• Refer to INSTALLING TRUNK COMPARTMENT LIGHT ON TRUNK LID .
• Refer to INSTALLING THE POWER TAILGATE SWITCH .
• Refer to INSTALLING THE TRIM FOR THE LEFT AND RIGHT SIDE REAR WINDOW FRAME .
• Refer to INSTALLING THE TRIM FOR THE TOP REAR WINDOW FRAME .
• Refer to INSTALLING THE TAILGATE TRIM STRIP .