Installing the control unit for the Front Light Electronics Left (FLEL)

• Check the seal (3) on the control unit for the Front Light Electronics (2) for damage and replace if necessary.
• Connect connectors (1) and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

  Check 

  • After locking: The plug connection must be checked for correct, firm fit.

  Courtesy of BMW OF NORTH AMERICA, INC.

  Result 

  » The firm fit is not correct.

  Measure

  • Disconnect the connectors and check the locking mechanism for mechanical damage.

  Measure

  • Replace the damaged plug components.

  Measure

  • Fit, insert and lock the connector at a right angle to the direction of insertion.

  Measure

  • Check correct firm fit again.
• Position the control unit for the front light electronics (2) in the headlight.
• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Frontal Light Electronics (FLE)
  PT-SCREW 40x12	tightening torque	1.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to PROCESSING THE LED HEADLIGHT SERVICE TEST MODULE .