Install the rear window
- Check the hook and loop tape (Dual Lock tape) (1) on the body and the rear window for damage and availability.
A damaged or missing hook and loop tape (Dual Lock tape) (1) must be replaced.
- Check the spacer buffer (1) for damage and availability.
Damaged or missing spacer buffers (1) must be replaced.
- Keep 2 glue cartridges ready.
- Prepare 1 glue cartridge with the standard nozzle C.
- Apply bead joint in area (1).
- Apply adhesive bead within the mark on the rear windowTECHNICAL DATA SPECIFICATION
Adhesive bead b = Width 7 mm... 9 mm h = Height 11 mm... 13 mm - Carefully perform the following actions on the rear window (1) with the suction lifter
- Bring it parallel to C-pillar
- apply and press at the bottom on the seal
- Align sides evenly
- evenly press all around and snap-in at the hook and loop tapes (Dual Lock tape)
- Make sure that the seal (2) lies evenly on the tailgate (3).
- Secure rear window (1) with adhesive tap on the roof.
- Remove adhesive tape (1).
- Attach the cable to the cable brackets (3).
- Connect connectors (2) and lock.
- Tighten down screw (1).TIGHTENING TORQUE SPECIFICATIONS
Ground strap to trunk lid Oval-head screw tightening torque 4.5 Nm - Attach the cable to the cable brackets (3).
- Connect connectors (2) and lock.
- Tighten down screw (1).TIGHTENING TORQUE SPECIFICATIONS
Ground strap to trunk lid Oval-head screw tightening torque 4.5 Nm - Connect connectors (1) and lock.
Follow-up work
- Refer to INSTALLING REAR WINDOW WIPER MOTOR .
- Refer to INSTALLING WIPER ARM OF THE REAR WIPER .
- Refer to FITTING THE LOWER PART OF THE REAR SPOILER .
- Refer to INSTALLING REAR SPOILER .
- Refer to INSTALLING THE TAILGATE TRIM PANEL .
- Refer to INSTALLING TRUNK COMPARTMENT LIGHT ON TRUNK LID .
- Refer to INSTALLING THE POWER TAILGATE SWITCH .
- Refer to INSTALLING THE TRIM FOR THE LEFT AND RIGHT SIDE REAR WINDOW FRAME .
- Refer to INSTALLING THE TRIM FOR THE TOP REAR WINDOW FRAME .