3712 Rear Stabilizer Bar, Rear Strut, Rear Air Suspension
3712 TIGHTENING TORQUE OVERVIEW
| Active stabilizer to right-hand retainer | ||
| M6 | Tightening torque | 8 Nm |
| Rear spring strut/air suspension on body | ||
| M10 Replace screw. |
Joining torque | 56 Nm |
| Angle of rotation | 90° | |
| Rear spring strut/air suspension on camber control arm | ||
| M14 Replace screw and nut. Tighten in normal position. |
Joining torque | 165 Nm |
| Angle of rotation | 90° | |
| Special tool on spring strut/air suspension | ||
| Clamp A on spring strut/air suspension | Tightening torque | 40 Nm |
| Special tool to joint bush | ||
| Clamp B on joint bush | Tightening torque | 40 Nm |
| Wiring harness for active stabilizer to right-hand retainer | ||
| M6 | Tightening torque | 8 Nm |
| Wiring harness for active stabilizer to right rear axle support | ||
| M6 | Tightening torque | 8 Nm |