Installing the speaker in the headlining
- Insert the speaker (1) in the holder (2) on the headlining (3).
- Connect connectors (4) and lock.
- Close the insulation (3).
- Snap-in the locks (1) on the holder (2) for the speaker.
Installing the speaker trim on the headlining
- The locks (1) and (2) must not be damage; replace the speaker trim (3) if necessary.
- Insert the speaker trim (1) in the headlining (2) and clip it in correctly at the marked points.
- Remove the yellow plastic adhesive tape (3).
Follow-up work
- Refer to INSTALLING THE HEADLINING (LOWERED) .
- Refer to INSTALLING REAR INTERIOR ROOF LIGHT .
- Refer to INSTALLING ALL GRAB HANDLES .
- Refer to INSTALLING ROOF FUNCTION CENTER (FZD) .
- Refer to INSTALLING COUNTER SUPPORTS FOR THE LEFT AND RIGHT SUN VISOR .
- Refer to INSTALLING THE LEFT AND RIGHT SUN VISOR .
- Refer to INSTALLING LEFT AND RIGHT A-PILLAR TRIM PANEL .
- Refer to PARTIALLY INSTALLING THE B-PILLAR TRIM PANELS AT THE TOP LEFT AND RIGHT .
- Refer to INSTALLING THE LEFT AND RIGHT C-PILLAR TRIM PANEL .
- Refer to INSTALLING D-PILLAR TRIM PANEL ON LEFT AND RIGHT .