Installing the speaker cover from the door trim panel
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Saw off all welding pins on the speaker cover (1) along the molding (2).
- Remove welding remnants on door trim panel with a scalpel.
- Install the speaker cover (1) and lock on the detents (2).
Welding pins must not protrude from the door trim panel.
- Screw in and tighten the repair screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Decorative strip/speaker trim to door trim panel | ||
|---|---|---|
| screw | Tightening torque | 1.8 Nm |
Follow-up work
- Refer to INSTALLING THE DECORATIVE STRIP ON THE DOOR TRIM PANEL .
- Refer to INSTALLING REAR DOOR TRIM PANEL .