When replacing the module bracket on the front door: Remount components
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
RISK OF DAMAGE
Careless handling of tools and sharp-edged components .
Scratches, surface damage .
Careless handling of tools and sharp-edged components .
Scratches, surface damage .
- Protect working area.
- Handle tools and components carefully.
Preliminary work
- Refer to DEACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to REMOVING THE MIRROR TRIANGLE COVER . .
- Refer to REMOVING FRONT DOOR TRIM PANEL .
- Refer to REMOVING THE EXTERIOR MIRROR ON THE FRONT DOOR .
- Refer to REMOVING THE WINDOW CHANNEL STRIP ON THE OUTSIDE OF THE FRONT DOOR .
- Refer to REMOVING THE MODULE BRACKET FROM THE FRONT DOOR .
Removing airbag sensor from the front door
- Unlock plug connection (1) and disconnect.
- Unlock the latch mechanism (2).
- Turn and remove airbag sensor (3) in the arrow direction.
Removing flat motor for the front power windows
- Release wiring harness with the detents (1).
- Lift the sound insulation (2) in the area of the flat motor.
- Unlock plug connection (3) and disconnect.
- Feed out and remove the sound insulation (1) at the openings (2).
- Undo screws (1) and remove the flat motor (2).
Remove the mid-range speaker from the front door
- Disconnect plug connection (1).
- Loosen screws (2).
- Remove the mid-range speaker (3).
- Replace the module bracket on the front door.
Parts: Module bracket
Installing airbag sensor in the front door
- Correctly position the airbag sensor (3) and turn it in the direction of the arrow until the detent (2) engages.
- Connect connectors (1) and lock.
Installing flat motor for front power windows
- Correctly position the flat motor (1) and tighten screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Flat motor to module carrier | ||
|---|---|---|
| Thermoplastic screw | Tightening torque | 6 Nm |
- Insert the sound insulation (1) at the openings (2).
- Connect connectors (1) and lock.
- Clip in the wiring harness with the detents (2).
- Mount sound insulation (3).
Installing the mid-range speaker in the front door
- Position the mid-range speaker (3).
- Tighten screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Loudspeaker to dashboard/loudspeaker to door | ||
|---|---|---|
| screw | Tightening torque | 1.8 Nm |
- Connect plug (1).
Follow-up work
- Refer to INSTALLING THE MODULE BRACKET ON THE FRONT DOOR .
- Refer to INSTALLING THE WINDOW CHANNEL STRIP ON THE FRONT DOOR ON THE OUTSIDE .
- Refer to MOUNTING THE OUTSIDE REARVIEW MIRROR ONTO THE FRONT DOOR .
- Refer to INSTALLING FRONT DOOR TRIM PANEL .
- Refer to MOUNTING MIRROR TRIANGLE COVER .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .