Adjust the striker for lower section of tailgate left or right

WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: TECHNICAL INFORMATION
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: BODY DIMENSIONS .

NOTE: Description is for left component only. Procedure on the right side is identical.

Release the rubber cover (1) and fold down as shown.

Courtesy of BMW OF NORTH AMERICA, INC.
Slacken the bolts (1) until the striker (2) is barely adjustable and self-centers itself.
Close trunk lid.
Open trunk lid.
Tighten the screws (1).

NOTE: When the trunk lid is closed, the striker must not tap or scrape against the tailgate lock. Watch out for scratches!

TIGHTENING TORQUE SPECIFICATIONS

Striker to rear lid
screw	Tightening torque	19 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Close the trunk lid and check the gap dimension.
If applicable, repeat the adjustment procedure.

Follow-up work

Refer to INSTALLING THE COVER ON THE STRIKER FOR THE TAILGATE LATCH .